Home > News > Company News

Correct replacement process of pp melt blown filter cartridge

Time: 2021-01-27

View: 116

Correct replacement process of pp melt blown filter cartridge

The filter cartridge has a certain service life. If the filter cartridge that reaches the end of life is not replaced in time, the effect of concern cannot be achieved. The same applies to the use of pp melt blown filter cartridges. What Wuxi Lycra wants to share with you is the replacement process of pp melt blown filter cartridges. Let’s do a simple understanding!

 

1. After receiving the instruction to replace the pp melt blown filter cartridge, confirm that the system has stopped running.

 

2. Prepare suitable PP melt blown filter cartridge (specification, material, size, sealing gasket, model, etc.), disassembly tools, etc.

 

3. Thoroughly clean the filter housing, clean the surrounding filters, leave it in the operating area, and bring protective equipment.

 

4. The filter of the PP melt blown cartridge will need to be replaced and disconnected from the system. Slowly open the top vent of the filter to release the pressure. Pay attention to safety during the process to prevent materials or liquids from splashing.

 

5. Empty the material in the filter, use a tool to open the filter cover, remove the large fat melt spray filter cartridge, and put the filter cartridge in a plastic bag for cleaning or scrapping.

 

6. Use clean tools and rags to clean the inside of the filter. A clean PP melt blown filter cartridge is to be installed.


 pp melt blown filter cartridge


7. Open the plastic bag at the end of the filter opening to check whether the sealing gasket is perfect and in place.

 

8. Install the inflow of materials according to the method of inflow from the outside of the pp melt blown filter cartridge and out of the inside.

 

9. Use a suitable wetting agent (such as water) to wet the sealing gasket and the socket of the filter seat. Place one end of the PP melt blown filter cartridge close to the sealing gasket, and insert the socket of the filter cartridge vertically and completely into the socket of the filter seat. After inserting the filter cartridge, remove the filter cartridge packaging bag, then install the filter cover and tighten the filter with tools.

 

10. Close the filter drain, open the air release valve on the top of the housing, and open the inlet valve slightly to allow the material to enter the shell until the liquid overflows from the air release valve on the top of the shell. At this time, close the air release valve and carefully inspect the disassembly site Whether there is a leak.

 

11. Slowly open the filter outlet valve until it is fully opened.

 

12. Remove the replacement tools and cleaning tools. Clean the surrounding area.

 

The PP melt blown filter cartridge machine of Wuxi Lycra Automation Technology Co., Ltd. can process up to 6000 Pixar 10 inch pp melt blown filter cartridges per day, but the power consumption is very low, only 30kw/h. We are the best pp melt blown filter cartridge machine supplier of China. Please feel free to contact us.